Cleveland-motion-controls WebPro Intermediate Tension Controller MWP-12663 R Manual de usuario descargar pdf (Pagina 12)

AO-70174 12 Revision BA

WebPro Intermediate Tension Controller

Machine Parameters

From the Commissioning Menu; press 1 to show the Machine Parameters screen

Machine Parameters (SET UP = cancel)

changed

by using

default

value

Language English Deutsch Français Italiano Español

Unit system S.I. / Metric kgf / Pound/foot / Percent

Controller application Intermediate

Transducers before Before / After

or after main motor

Output trim only Yes / No

Output range +/- 2V / +/- 10V

Start in control screen No / Yes

Enable MAN/AUTO/OFF keys No / Yes

Dual tension range No / Yes

Full scale (low) Enter a value

Full scale (normal) Enter a value

Minimum tension 3% minimum, 20% maximum

Output level bias 20% maximum

Output level limit 100% maximum

Set point ramp rate 1% per second, 100% per second

Display damping time 0.1 seconds, 3 seconds

Display precision 0.1, 0.5, 1, 5, 10

Digital inputs

MACHINE START Disabled, 0V=OFF, 0V=ON

SELECT AUTO Disabled, 0V=OFF, 0V=ON

SELECT MANUAL Disabled, 0V=OFF, 0V=ON

SELECT OFF Disabled, 0V=OFF, 0V=ON

DIAMETER HOLD Disabled, 0V=OFF, 0V=ON

DIAMETER RESET Disabled, 0V=OFF, 0V=ON

BATCH HOLD Disabled, 0V=OFF, 0V=ON

ENABLE EXT SP Disabled, 0V=OFF, 0V=ON

Show internal calibration * No / Yes

Right transducer Disabled, Enabled

Line tacho or encoder * Disabled, Tacho, Encoder

+/-

numeric key

+/-

English

S.I.

before

0-10V

5000N

100%

5%/sec

2 secs

Disabled

An asterisk * indicates that a further menu will open if this item is selected.

Remember to press the CONFIRM key, otherwise the parameters will not be saved to the memory.

Note Start in Control Screen

The Controller is despatched with this item set to "No". We recommend that after all commissioning is

finished that this is then set to "Yes". When the Controller is now switched on, the program is loaded, the

company logos are shown briefly and then the Control or operating screen ready for use by the operator.

Note

The Controller will not accept an invalid input value which is outside the limits of operation. If an invalid

input is attempted the Controller will revert to the previous valid input.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Cleveland-motion-controls WebPro Intermediate Tension Controller MWP-12663 R Manual de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Cleveland-motion-controls WebPro Intermediate Tension Controller MWP-12663 R