Cleveland-motion-controls Quantum Tension Controller REV A Manual de usuario descargar pdf (Pagina 17)

2.0

Menu INPUTS

2.1 Measure Menu

This menu appears when choosing closed loop, inertia correction,motor command or speed

follower. It allows calibration for any type of measurement, from a few mV to 10V.

Measure calibration

% full scale: Type in the percentage of full scale corresponding to the upper point used

during calibration (this percentage must be more than 20%).

Valid high level: Type in the value for the upper point.

Valid low level: Type in the value for the lower point.

Procedure:

Fill the 3 parameters and then click on the memory used. Then physically simulate the upper

point and click "valid high level," wait 5 seconds (yellow button), physically simulate the lower

point and click "valid low level," wait 5 seconds (yellow button); calibration is complete.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

Sin comentarios

Cleveland-motion-controls Quantum Tension Controller REV A Manual de usuario Pagina 17