Cleveland-motion-controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA Manual de usuario descargar pdf (Pagina 23)

MAN-70430-0 REV AA ULTRA SERIES STATIONARY SHAFT TRANSDUCER TECHNICAL MANUAL

4.2.2 MOUNTING CONFIGURATIONS

Ultra Series Cartridge Transducers can be mounted on either the inside or outside of the machine frame

depending on the model type purchased (refer to Figure 10 and Table D). When choosing a mounting

confi

guration, evaluate your options by taking the following points into consideration:

 Model type

 Safety

 Machine Frame orientation

 Ease of Assembly

MACHINE FRAME

TYPE "S"

MOUNTING

TYPE "FL"

MOUNTING

SENSING ROLL SENSING ROLL

TYPE "PB"

MOUNTING

TYPE "BR"

MOUNTING

STATIONARY/DEAD SHAFTSTATIONARY/DEAD SHAFT

MACHINE FRAME

Figure 10– Types of Mounting Configurations

Table D – Mounting Type and Connector Compatibility

The Connector can be located

at:

When using this type of Mounting

Configuration:

End Side

Flange (FL)

X w/hole X

Stud (S)

Pillow Block (PB)

Bearing (BR)

The tension-sensing roll must not be located where the web wrap angle can vary, or the transducer will not

interpret the tension properly as the angle varies. If a variance in the wrap angle occurs, it is sensed by the

transducer as a tension change and the change is indicated on the tension indicator. In cases where it is

impossible to mount the transducer where the wrap angle does not vary, the change in indicated tension that

results should be calculated and if sufficiently small, can be disregarded.

WRAP VARIESWRAP VARIES

PROCESS

OK FOR TENSION SENSING

Figure 11 - Example of Varying Wrap Angles

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Comentarios a estos manuales

Sin comentarios

Cleveland-motion-controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Cleveland-motion-controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA