Cleveland-motion-controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA Manual de usuario descargar pdf (Pagina 37)

MAN-70430-0 REV AA ULTRA SERIES STATIONARY SHAFT TRANSDUCER TECHNICAL MANUAL

4.17 Cable Glands

Several manufacturers provide cable glands that can be used to ensure the integrity of the EMC

requirements when installing this equipment in the enclosure. The objective of the cable gland is to

provide a good mechanical entry into the enclosure to protect the cable and also provide an electrical bond

the outer shield (screen) of the cable to the enclosure.

The following is a list of cable gland venders and the range of cable sizes that each vender can provide.

This is not an endorsement or promotion of any particular vender or manufacturer; the information is

provided only to assist you in the application of the product described in this document.

Cable Gland Vendor Cables

Sealcon

14853 E. Hinsdale Ave., Suite D

Englewood, CO 80112, U.S.A.

Tel: (303)699-1135 Fax: (303)680-5344

Tel: (800)456-9012

EMI-Proof Grounded Nickel Plated Brass Liquid Tight Strain

Relief Fittings

Standard and Feed-through types

Cable diameters from 0.11 inches to 1.38 inches

Metric (PG) or NPT thread types

Optional metric (PG) to NPT adapters

GlobTek, Inc.

186 Veterans Drive

Northvale, NJ 07647

Tel: (207)784-1000 Fax: (210)784-0111

URL: www.globtek.com

Standard, IP68 protection

Index EMC Cable Glands

Cable diameters from 6.0 mm to 20.0 mm

Metric threads

Wiedmuller

Tel: (800)849-9343 Fax: (800)794-0252

Bulkhead Cable Glands for Braid/Armour Termination

Standard types KGC 1 Series

Cable diameters from 1.8 mm to 39.9 mm

Metric threads

Optional washers and locknuts

Belden

Braided “overshield” wire; Belden #8669 (0.5” I.D.) braided

shielding and bonding wire

1 2 ... 32 33 34 35 36 37 38 39 40

Sin comentarios

Cleveland-motion-controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA Manual de usuario Pagina 37